Return to previous page

SEM433 - Mechatronic Design

Unit details

Year2016 unit information
Enrolment modes:Trimester 1: Waurn Ponds (Geelong), Cloud (online)
Credit point(s):1
EFTSL value:0.125
Cohort rule:

Only available to students enrolled in a Bachelor of Engineering (Honours) or associated combined degrees (D37%)

Unit chair:

Matthew Joordens

Prerequisite:

SEE321 and 1 unit from SEE316 or SEE320

Corequisite:

Nil

Incompatible with: SEM332
Contact hours:

Campus: 2 x 1 hour classes per week (weeks 1-5), 1 x 1 hour seminar per week (weeks 1-5), 1 x 3 hour practical per week (weeks 6-11) Students must attend and participate in practical activities for this unit at scheduled sessions on multiple days during the trimester.

Cloud (online): Learning experiences are via CloudDeakin. 1 x one-day demonstration session per trimester. Students must attend and participate in practical activities at the Geelong Waurn Ponds Campus on the particular scheduled day during the trimester intensive week.

Content

This unit integrates the knowledge gained in the electrical, electronic, microprocessor, mechanical and control units of the Bachelor of Engineering (Mechatronics) course.  It covers locomotion, PCB design, power requirements, autonomous control and sensor design and application.  Students are required to design and construct an autonomous robot project.

Assessment

Two reports (20%, 30%) 50%, project demonstration 40%, project construction 10%. To be eligible to obtain a pass in this unit students must achieve at least 50% in both of the project demonstration and construction assignments (this includes an oral component that must be passed). 

Unit Fee Information

If you are:

Domestic

  • in a Commonwealth Supported Place (CSP) - refer to Unit based calculation below.
  • an undergraduate full fee paying student - refer to Unit based calculation below.
  • postgraduate full fee paying students commenced before 2016 - refer to Unit based calculation below.
  • postgraduate full fee paying students commencing in 2016 - refer to Course based calculation below.
  • a non-award student - refer to Unit based calculation below.

International

  • an undergraduate, postgraduate or Higher Degree by Research student commenced before 2016 - refer to Unit based calculation below.
  • an undergraduate, postgraduate or Higher Degree by Research student commencing in 2016 - refer to Course based calculation below.
  • a non-award student - refer to Unit based calculation below.

Course based calculation

Your unit tuition fees are based on the course you are enrolled in. Please refer to the current year's course entry to estimate the unit cost.


Unit based calculation

Your tuition fees are calculated on the units you enrol in. This means your fees are based on the units you choose to study and not a fixed course price. The tuition fees for this unit are displayed in the table below:


Student Contribution Rate*Student Contribution Rate**Fee rate - Domestic Students Fee rate - International students
$1114$1114$3696$3772

* Rate for all CSP students, except for those who commenced Education and Nursing units pre 2010
** Rate for CSP students who commenced Education and Nursing units pre 2010
Please note: Unit fees listed do not apply to Deakin Prime students.

Return to previous page